Elliptical Gear with no center pivot

Elliptical Gear with no center pivot

A slight remix of PerryT's wonderful Elliptical Gear set. I liked playing around with the gears connected at the off-center pivots, and thought it would look cool to remove the center ring entirely.

Print Settings

Rafts: No

Supports: No

Resolution: 0.2 or 0.3 mm


Make sure the holes are smooth and pop in the pins gently.

Be aware that the left and right sides of the gear have different teeth positions with respect to the hole. Thus, you may need to rotate one of the gears 180 degrees to get the right alignment. If this doesn't make sense, look at the photos below.

Correct Alignment:

Incorrect Alignment (right gear was rotated 180 degrees):

The needed files for the print you can find here!


Source: https://www.thingiverse.com

Write By: admin Published In: Projects Created Date: 2017-07-30 Hits: 1003 Comment: 0